Motorcycle Classics and Dairyland Cycle Insurance are building a retro bobber — and you could win it!
Here’s what our brand new Bonneville looked like when it arrived at the MC offices.
We're going to drop our Triumph down a little closer to the ground, and to do that we'll install a set of shorter aftermarket performance shocks and also push the front forks a little farther up into the steering yokes.
Proably the hardest part of our afternoon's work was removing the stock exhaust system, which we'll be replacing with an aftermarket unit. The first step in removing the exhaust is loosening the crossover pipe connecting the left and right sides.
Here’s our brand new Bonneville after an afternoon spent pulling it apart. Now the real work begins - putting it together the way we want it!
Next up is removing the nuts holding the header pipes to the cylinder head. Best practice is to just crack the nuts loose, one after the other, before loosening them completely.
Here you can see the rear header pipe mount. There's no good way to remove this bolt without first removing the side cover and the foot peg/brake pedal assembly.
To get to the bolt that holds the rear of the header pipe you have to remove the right side cover, shown removed here, followed by the right side foot peg/brake pedal assemly, which you'll see in the next photo.
Removing the headlamp shell is easy because the wiring is mostly fool proof thanks to unique terminal ends for each cluster of wires - with the exception of the turn signals, which use the same black/white wiring left and right but plug into different colored receptacles. We made sure to tag the wires in the loom for left and right signals.
The muffler is held on at the rear by the rear footpegs. We're going to install a solo saddle which means we won't need rear footpegs, so these aren't going back on.
After removing the side cover we also removed the right side foot peg/brake lever assembly. That's necessary to access the bolt that holds up the rear of the header pipe, which you'll see in the next photo. This photo shows the exhaust system already removed.
Here's a closer view of the rear of the frame with the fender removed. We're going to cut or "bob" the upper frame rails where they kink inwards before reaching back to the rear of the bike. The wiring will all nest nicely under the solo saddle we're going to install.