Motorcycle Classics

Yamaha SR500 Petcock Challenges

Reader Contribution by Keith Fellenstein

Editor’s note: If you’re having trouble with that old Suzuki, BSA or BMW, Keith Fellenstein is your guy. From motorcycle tuning tips to detailed motorcycle engine repair, he can draw from a wealth of experience to help guide you to success. Send questions to: Keith’s Garage, Motorcycle Classics, 1503 SW 42nd St., Topeka, KS 66609, or send an e-mail with “Keith’s Garage” as the subject.

Q: My 1979 Yamaha SR500 has a vacuum fuel petcock. I’ve found no way to eliminate it for a simple gravity-style petcock. I installed an inline fuel shut-off in the fuel line below the petcock. When I’m done riding, since the stock petcock has no “off” position and relies on engine vacuum to allow fuel flow, I turn the inline one to “off” and let the carburetor run dry to eliminate any gas going stale inside the carburetor. My problem is, when I go to start it, it takes anywhere from 5 to 20 kicks to get it started. The engine is running a 1980 Hi-Per-Kinetics Stage Two 650 stroker with 97mm x 88mm bore and stroke, a Megacycle 5120HP cam, Mikuni VM36 and other goodies.

I’ve owned three Yamaha TT500s, and they all had the on/off/reserve manual petcocks and all started first kick, hot or cold. How can I eliminate the funky stock petcock without replacing the tank? Does it require a lot of kicks to get the fuel flowing from the petcock because of the engine modifications? Should I just not run the carb dry after riding? I use octane booster and fuel preservative. The bike had sat for over 25 years when I bought it in 2012. The inside of the carburetor was surprisingly clean, with no gum at all. — David Fruhling/via email

A: It is taking so many kicks because there would normally be enough gas in the carburetor to start, then engine vacuum would open the petcock and refill the bowl before it ran dry. There should be a “PRI” or prime position on the petcock that bypasses the vacuum and flows gas to the carb for those instances when the bowls are dry, such as after a carb rebuild. After a little searching I found a good option. It’s an adapter that bolts directly to your tank and allows you to use a standard non-vacuum petcock. They also offer the petcock that fits the adapter, making it a one stop shop. Don’t forget to plug the vacuum port on the intake manifold.

  • Published on Jul 5, 2018
© Copyright 2022. All Rights Reserved - Ogden Publications, Inc.